Showing 10–18 of 25 results
The M&K Sound BMC-1 is a balanced, line-level studio bass management controller intended for use with M&K Sounds line of professional studio monitors and with high-end home theater installations. Although the BMC-1 was primarily designed for monitoring 5.1 audio, its flexible architecture allows it to be used for monitoring mono, stereo, Dolby Surround, Dolby Digital, DTS and other formats.
The BMC-1 combines several necessary functions in one 19 rack mount 1RU package. Along with bass management and LFE channel control, it also provides individual channel adjustment capability to properly calibrate your entire monitor system.
The controller consists of a series of five high-pass filters (one each for the L, C, R, LS, RS channels) that route high frequency information (above 80Hz) to their appropriate channels amplifier and speaker. Each channel is also routed through a matching 80Hz lowpass filter. This low frequency information is then routed to a summing amplifier, which in turn sends this low frequency information, along with the LFE channel, to two subwoofer outputs.
This is done for two reasons. First, small loudspeakers may not be able to properly reproduce information below 80Hz. This information is therefore summed together and redirected from the individual channels to a loudspeaker that can reproduce this low frequency information with clarity and power “ a subwoofer. With the introduction of digital audio, it has become necessary for loudspeaker systems to be able to accurately reproduce audio that has a bandwidth of 20Hz to 20kHz with wide dynamics. A satellite/subwoofer system is the best way to accomplish this.
Secondly, todays home theater receivers utilize bass management per Dolby requirements. In order for work done in the studio to translate properly, the mixer must hear his mix exactly the way it will ultimately be played back. The BMC-1 together with a properly set-up and calibrated M&K Sound monitor system allows the mixer to hear his work with more accuracy than might otherwise be possible.
Front Panel Trim Controls +/- 12dB trim control for balancing the system.
Featured with dual Push Pull coupled long stroke 10” drivers in sealed enclosure.
Combining digital switch mode power section of 350 watt RMS, with M&K propietary analog “front-end” input stage, all designed for the legendary M&K Sound bass extension.
The M&K X10 subwoofer offer very low distortion and high dynamic performance, as using “dual Push Pull coupled drivers” providing a total surface area most equivalent to a single 15” driver.
X10 is multible rewarded for high quality performance in music and movie production, and Home Theater applications.
Featured with dual Push Pull coupled long stroke 12” drivers in sealed enclosure.
Combining digital switch mode power section of 400 watt RMS, with M&K propietary analog “front-end” input stage, all designed for the legendary M&K Sound bass extension.
The M&K X12 subwoofer offer Ultra low distortion and the highest dynamic performance, as using “dual Push Pull coupled drivers” providing a total surface area most equivalent to a single 18” driver.
X12 is rewarded with “reference status” for music and movie production,and Home Theater applications.
Featured with dual Push Pull coupled long stroke 8” drivers in sealed enclosure.
Combining digital switch mode power section of 300 watt RMS, with M&K proprietary analog “front-end” input stage, all designed for the legendary M&K Sound bass extension.
The M&K X8 subwoofer offer the Push Pull technology in a compact size, performing with remarkable low distortion and extended dynamic range. The Push Pull coupled 8” drivers” provide a total surface area most equivalent to a single 12” driver.
More than four decades of experience and insight have been applied to the design of this truly invisible subwoofer, based on high-performance 8” woofers specially developed for the M&K Sound V Series subwoofers and ingeniously adapted to meet the extreme demands of shallow, flush-mount installation while delivering the quantity and quality of deep bass that consumers and professionals expect from M&K Sound.
The specially tuned, ultra-fast, mass-loaded dual drivers employ aluminum shorting rings for minimal voice coil distortion at long excursion. Highly rigid paper pulp cones with high inner damping ensure stability at extreme levels and low resonance.
The ultra-linear solid ferrite magnet system provides effective dissipation of heat from the voice coil to prevent power compression from limiting the acoustic output of the system.
The drivers are installed in full contact with the front baffle and the rear of the box for ideal mechanical stability to minimize driver resonances that can occur due to the limited volume of an In-Wall enclosure.
The IW28s needs the VA500 Subwoofer Amplifier.
Equipped with a 10” polyfiber woofer and a 150W class D amplifier, the Jamo Studio S 810 SUB delivers dynamic, powerful bass in any listening environment – from full cinema surround systems to critical 2-channel listening.
The new Jamo Studio 8 series has been completely reimagined to live seamlessly in modern, premium environments. Contemporary material and finish choices accentuate the clean, minimalist lines of this European design, while the compact cabinet designs are an ideal solution for urban living environments around the world
Featured with single 10” driver in sealed enclosure, combining digital switch mode power section of 200 watt RMS, with M&K proprietary analog “front-end” input stage designed for the legendary M&K Sound bass extension.
The M&K V10 subwoofer delivers low distortion and high dynamic performance in a very compact format.
Featured with single 8” driver in sealed enclosure, combining digital switch mode power section of 150 watt RMS, with M&K proprietary analog “front-end” input stage designed for the legendary M&K Sound bass extension.
The M&K V8 subwoofer delivers low distortion and high dynamic performance in a ultra compact format.
Rayno sits on the board of Directors as a shareholder. He has been with the company since 2003, originally working as an employee in the position of Sales Manager. At that time it was a far smaller enterprise, consisting of 1 branch with 6 staff members. In 2008 the original owner sold the company to the van Heerden family, who officially took over as of May 2008 and have since managed to grow it into what it is today.
Rayno has created and maintained excellent relationships with motor manufacturers.
Thanks to him, Planetworld is a supplier to the likes of Nissan, Suzuki, Mitsubishi, Ford, Subaru, Datsun, KIA, Haval and Toyota to mention a few. Along with his team, Rayno sources products then, working closely with the manufacturer, helps develop and customise them to suit the South African market. To date, he has created inhouse brands – OneNav, Planet Multimedia, Smart Mirror and TyreTech.
Rayno credits his obsession with service and his dedication to customer satisfaction to his 15-year career as a waiter. He’s always had an adventurous side enjoying hobbies such as hang gliding, skateboarding, surfing and trail running. As per family tradition, Rayno loves his music and plays a number of instruments, even having composed a few of his own original songs.